Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 61

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 276
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 60
Configuring Global BGP Parameters
308628-15.0 Rev 00
3-17
Using Site Manager
To configure the BGP slot mask, complete the following steps:
Disabling and Reenabling Route Aggregation
By default, BGP aggregates non-BGP-originated subnet routes to their
corresponding natural network routes for advertisement to BGP peers. Disabling
route aggregation causes BGP to advertise each subnet.
You can use the BCC or Site Manager to disable this feature. (This switch does
not affect the advertisement of BGP-originated routes.)
Using the BCC
To disable or reenable route aggregation for non-BGP-originated subnet routes, go
to the BGP prompt (for example,
box; ip; /jointfilesconvert/97454/bgp
) and enter:
subnet-aggregation
<
state>
state
is either
enabled
(default) or
disabled
.
For example, the following command disables subnet aggregation:
/jointfilesconvert/97454/bgp#
subnet-aggregation disabled
/jointfilesconvert/97454/bgp#
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
BGP
. The BGP menu opens.
4. Choose
BGP Global
. The Edit BGP Global Parameters window
opens.
5. Set the
BGP Soloist Slots
parameter.
Click on
Help
or see the parameter
description on page A-7
.
6. Click on
OK
. You return to the Configuration Manager
window.
Vista de pagina 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 275 276

Comentarios a estos manuales

Sin comentarios