
Configuring IP Exterior Gateway Protocols (BGP and EGP)
A-44
308628-15.0 Rev 00
Parameter: BGP Communities to Match
Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-4 > Accept
Policies
Default: An empty list
Options: A list of BGP communities
Function: Specifies one or more BGP communities. This policy applies to all BGP
advertisements that match the list.
Instructions: Supply an octet string using the following format: each community ID is 4 bytes
long; 0 in the two most significant bits causes the router to perform the match on
the lower 16 bits; the default empty list means “match any list.”
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.9.1.20
Parameter: AS Prepend
Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-4 > Accept
Policies
Default: An empty list
Options: A list of autonomous systems
Function: Specifies one or more AS numbers to be added as a SEQUENCE to AS Path.
Instructions: Supply an octet string containing AS numbers to be added as a SEQUENCE to
AS Path.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.9.1.23
Parameter: BGP Community to accept
Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-4 > Accept
Policies
Default: An empty list
Options: A list of BGP communities
Function: Specifies one or more BGP communities. This list identifies which communities
are associated with this rule.
Instructions: Supply an octet string using the following format: each community ID is 4 bytes
long; 0 in the two most significant bits causes the router to perform the match on
the lower 16 bits; the default empty list means “accept any list.”
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.9.1.24
Comentarios a estos manuales