Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 114

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 276
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 113
Configuring IP Exterior Gateway Protocols (BGP and EGP)
5-4
308628-15.0 Rev 00
Table 5-1. BCC Definition Parameters for BGP Accept Policies
Parameter Values Function
action ignore (default)
accept
Specifies whether BGP ignores a route
that matches the policy or forwards the
route to the routing table manager
as-weight-class class1 (default) to
class 8
Indicates the weight class value to use
when calculating the AS path weight
/jointfilesconvert/97454/bgp4-preference 1 (default) to 16 Specifies a value used to compare a route
that matches this policy with other BGP-4
routes. The larger the value, the greater
the preference.
precedence 0 (default) to any
positive integer
Assigns a metric value to this policy (a
policy with a higher value takes
precedence over a policy with a lower
value). This value determines the order of
precedence for policies that match the
same route.
preference 1 (default) to 16 Assigns a metric value (the higher the
number, the greater the preference) to a
route that BGP forwards to the routing
table manager. If confronted with multiple
routes to the same destination, the routing
table manager may use this value to
decide which route to insert. Routes for all
networks (0.0.0.0/0.0.0.0) should have the
lowest preference, and routes for the most
specific networks (longest address and
mask) should have the highest preference.
route-damping enabled
disabled (default)
Configures BGP to perform route flap
damping on a route that matches this
policy. For instructions on configuring an
accept policy for route flap damping, see
Configuring EBGP Route Flap Damping
on page 3-31.
route-damping-template default or a unique
template name (up
to 20 characters)
Configures BGP to use the default
route-flap-damping template or the
template that you specify
state enabled (default)
disabled
Enables and disables the policy that you
created
Vista de pagina 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 275 276

Comentarios a estos manuales

Sin comentarios