
Configuring IP Exterior Gateway Protocols (BGP and EGP)
2-6
308628-15.0 Rev 00
Starting IP and EGP with Site Manager
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as an interface to an attached network. For information
and instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
After you configure the circuit, you can access the Site Manager Select Protocols
window.
To start IP and EGP from the Select Protocols window, complete the following
steps:
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select the
following protocols:
•
IP
•
EGP
Then click on
OK
.
The IP Configuration window opens.
2. Set the following parameters:
•
IP Address
•
Subnet Mask
•
Transmit Bcast Addr
•
UnNumbered Assoc Address
Click on
Help
or see the parameter
description in
Configuring IP, ARP, RARP,
RIP, and OSPF Services
.
3. Click on
OK
. The EGP Configuration window opens.
4. Set the following parameters:
•
Local Autonomous System ID
(decimal)
•
Remote Peer IP Address
•
Gateway Mode
Click on
Help
or see the parameter
descriptions beginning on page A-25.
5. Click on
OK
. Site Manager enables EGP service and
returns you to the Configuration Manager
window.
Comentarios a estos manuales