Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 182

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 276
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 181
Configuring IP Exterior Gateway Protocols (BGP and EGP)
A-8
308628-15.0 Rev 00
Parameter: Cluster Identifier
Path: Configuration Manager > Protocols > IP > BGP > BGP Global
Default: 0
Options: 0 to 4294967295
Function: Associates the IBGP route reflector with a cluster.
Instructions: If this BGP router is configured as an IBGP route reflector in a cluster, you must
specify a cluster ID. All IBGP route reflectors in the same cluster must have the
same cluster ID.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.1.18
Parameter: Aggregate Subnets
Path: Configuration Manager > Protocols > IP > BGP > BGP Global
Default: Enable
Options: Enable
|
Disable
Function: Specifies whether subnet routes from non-BGP sources are aggregated to their
corresponding natural network routes for advertisement to BGP peers.
Advertisement of BGP-originated routes is not affected by this switch.
Instructions: Set this parameter as required.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.1.22
Parameter: Black Hole Routes
Path: Configuration Manager > Protocols > IP > BGP > BGP Global
Default: Disabled
Options: Disabled
|
Drop
|
Reject
Function: Specifies whether BGP submits a black hole route to the routing table for an
aggregate route advertised to a BGP peer.
Instructions: To prevent BGP from submitting a black hole route to the IP routing table for a
route advertised to a BGP peer, set this parameter to Disabled. To drop a packet
for an unknown destination, set this parameter to Drop. To configure BGP to
return an ICMP destination unreachable message to the sender, set this
parameter to Reject.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.1.23
Vista de pagina 181
1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 275 276

Comentarios a estos manuales

Sin comentarios