
Configuring IP Exterior Gateway Protocols (BGP and EGP)
A-40
308628-15.0 Rev 00
BGP-4-Specific Accept Policy Parameters
Parameter: Injection List
Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-4 > Accept
Policies
Default: An empty list
Options: A list of network identifiers
Function: Specifies network IDs to be included in the routing table in place of the
network IDs listed in the received advertisement.
Instructions: Specify a non-null value only if the Action parameter is set to Accept. The
values you enter in the injection list determine the action taken.
If you supply a list of network IDs or the default network ID (0.0.0.0/0.0.0.0),
these IDs are injected into the routing table instead of the actual received IDs.
If you use the default value (an empty list), the actual received network IDs
are injected into the routing table.
The Injection List parameter does not perform route aggregation as defined in
RFC 1654. To aggregate routes in a transit AS, you must construct an
announce policy and use the announce Advertise parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.9.1.9
Parameter: Peer AS
Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-4 > Accept
Policies
Default: An empty list
Options: A list of autonomous system numbers (1 through 65,535)
Function: Specifies one or more ASs. This policy applies to BGP advertisements from
peers in the autonomous systems on this list.
Instructions: Use the default empty list to indicate that this policy applies to BGP
advertisements from peers in any AS.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.9.1.10
Comentarios a estos manuales