Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 39

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 276
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 38
Starting BGP and EGP Services
308628-15.0 Rev 00
2-3
Starting IP and BGP with Site Manager
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as an interface to an attached network. For information
and instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
After you configure the circuit, you can access the Site Manager Select Protocols
window.
To start IP and BGP from the Select Protocols window, complete the following
steps:
Note:
Before you configure BGP-4, see BGP Implementation Notes on
page 1-12 for information.
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select the
following protocols:
IP
BGP
Then click on
OK
.
The IP Configuration window opens.
2. Set the following parameters:
IP Address
Subnet Mask
Transmit Bcast Addr
UnNumbered Assoc Address
Click on
Help
or see the parameter
descriptions in
Configuring IP, ARP, RARP,
RIP, and OSPF Services
.
3. Click on
OK
. The BGP Configuration window opens.
4. Set the following parameters:
Identifier
Local AS
Click on
Help
or see the parameter
descriptions on page A-3.
5. Click on
OK
. The BGP Peer window opens.
(continued)
Vista de pagina 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 275 276

Comentarios a estos manuales

Sin comentarios