Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario descargar pdf (Pagina 210)

Configuring IP Exterior Gateway Protocols (BGP and EGP)

A-36

308628-15.0 Rev 00

BGP-3-Specific Accept Policy Parameters

Parameter: Injection List

Path: Configuration Manager > Protocols > IP > Policy Filters > BGP-3 > Accept

Policies

Default: An empty list

Options: A list of network identifiers

Function: Specifies network IDs to be included in the routing table in place of the network

IDs listed in the received advertisement.

Instructions: Specify a non-null value only if the Action parameter is set to Accept. The

values you enter in the injection list determine the action taken.

If you supply a list of network IDs or the default network ID (0.0.0.0/0.0.0.0),

these IDs are injected into the routing table instead of the actual received IDs.

If you use the default value (an empty list), the actual received network IDs are

injected into the routing table.

The Injection List parameter does not perform route aggregation as defined in

RFC 1654. To aggregate routes in a transit AS, you must construct an announce

policy and use the announce Advertise parameter.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.7.1.9

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 275 276

Sin comentarios

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 210