Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 89

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 362
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 88
Configuring and Customizing IP
117356-E Rev 00
3-27
Enabling MTU Discovery on an Interface
A probe MTU is a request for the maximum transmission unit (MTU) size used on
all networks that an IP datagram must traverse from source to destination.
By configuring IP to respond to probe MTUs on this interface, you eliminate
transit fragmentation and destination reassembly for datagrams destined for this
interface and, therefore, decrease network load.
The reply MTU and the probe MTU are options 11 and 12 in RFC 1063.
By default, IP does not respond to probe MTU requests. You can use the BCC or
Site Manager to turn this feature on and off as required.
Using the BCC
To enable or disable MTU discovery on an interface, navigate to an IP interface
prompt (for example,
box; eth 2/2; ip/2.2.2.2/255.255.0.0
) and enter:
mtu-discovery
<state>
state
is one of the following:
on
off
(default)
For example, the following command causes IP to respond to probe MTUs on
interface 2.2.2.2:
ip/2.2.2.2#
mtu-discovery on
ip/2.2.2.2#
Vista de pagina 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 361 362

Comentarios a estos manuales

Sin comentarios