
Configuring IP, ARP, RIP, and OSPF Services
B-18
117356-E Rev 00
Parameter: Outbound Interfaces
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Announce
Policies
Default: An empty list
Options: A list of IP addresses
Function: Specifies a list of outbound RIP interfaces. If an interface appears in this list,
the policy applies to RIP advertisements sent via that interface.
Instructions: Specify one or more IP addresses. Configure an empty list to indicate that this
policy applies to any outbound RIP interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.2.1.22
Parameter: RIP Metric
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Announce
Policies
Default: 0
Options: 0 or an export metric
Function: Specifies an optional export RIP metric to use when advertising a route that
matches this policy.
Instructions: Set the Action parameter to Announce. If you use the default, the RIP metric
is the routing table metric calculated for RIP plus the interface cost.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.2.1.23
Comentarios a estos manuales