Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 312

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 362
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 311
Configuring IP, ARP, RIP, and OSPF Services
B-4
117356-E Rev 00
Parameter: Route Preference
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Accept
Policies
Path: Configuration Manager > Protocols > IP > Policy Filters > OSPF > Accept
Policies
Default: 1
Options: 1 to 16
Function: Assigns a metric value (the higher the number, the greater the preference) to a
route that the protocol forwards to the routing table manager. If confronted with
multiple routes to the same destination, the routing table manager may need to
use this value to decide which route to insert.
Instructions: Either accept the default value, 1, or enter a new value. Routes for all networks
(0.0.0.0/0.0.0.0) should have the lowest preference and routes for the most
specific networks (longest address and mask) should have the highest
preference.
MIB Object ID: RIP: 1.3.6.1.4.1.18.3.5.3.2.6.1.1.7
MIB Object ID: OSPF: 1.3.6.1.4.1.18.3.5.3.2.6.3.1.7
Parameter: Rule Precedence
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Accept
Policies
Path: Configuration Manager > Protocols > IP > Policy Filters > OSPF > Accept
Policies
Default: 0
Options: A metric value
Function: Assigns a metric value to this policy (a policy with a higher value takes
precedence over a policy with a lower value).
Instructions: Use this value to specify the order of precedence for policies that match the
same route.
MIB Object ID: RIP: 1.3.6.1.4.1.18.3.5.3.2.6.1.1.8
MIB Object ID: OSPF: 1.3.6.1.4.1.18.3.5.3.2.6.3.1.8
Vista de pagina 311
1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 361 362

Comentarios a estos manuales

Sin comentarios