Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario descargar pdf (Pagina 38)

Configuring IP, ARP, RIP, and OSPF Services

1-16

117356-E Rev 00

Each area has a unique ID number. (ID 0.0.0.0 is always reserved for the OSPF

backbone.) The AS in Figure 1-5

has the following four areas:

• Backbone area: 0.0.0.0

• Normal areas: 0.0.0.1 and 0.0.0.4

• Stub area: 0.0.0.2

• Not-so-stubby area (NSSA): 0.0.0.3

For information about associating an OSPF interface with an area ID, see

“Configuring an Area ID” on page 6-20

Stub Area

A stub area does not import AS external routes and may or may not import

internal route summaries. In place of routes to destinations outside the stub area, a

border router connected to a stub injects a default route advertisement. When an

internal router encounters a datagram addressed to a destination outside the stub

area, the router forwards it to the border router specified in the default route

advertisement.

Not-So-Stubby Area (NSSA)

A not-so-stubby area (NSSA) is similar to a stub area except that, to a limited

degree, an NSSA can import AS external routes. Like a stub area, an NSSA

consumes less memory and CPU resources by preventing the flooding of type 5

AS external link-state advertisements (LSAs) into the area and by relying on

default routing to external destinations. However, unlike a stub area, an NSSA can

import external routes into an OSPF routing domain. You can also configure type

7 address ranges to allow NSSA border routers to control the summarization of

external routes for the NSSA.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 361 362

Sin comentarios

Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 38