Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 248

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 362
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 247
Configuring IP, ARP, RIP, and OSPF Services
A-8
117356-E Rev 00
Parameter: Address Resolution Type
Path: Configuration Manager > Protocols > IP > Interfaces
Default: ARP
Options: ARP
|
X.25 DDN
|
X.25 PDN
|
INARP
|
ARPINARP
|
NONE
|
X.25 BFE DDN
|
PROBE
|
ARP PROBE
|
ATMARP
Function: Specifies the address resolution scheme for this interface. The address
resolution scheme enables an originating end station to send broadcast packets
containing the network layer address to all nodes on a LAN. The specified end
station then sends a unicast packet containing the MAC address to the
originating end station.
Instructions: Depending on your network requirements, select one of these options:
ARP (default)
X.25_DDN
X.25_PDN
INARP only when all frame relay stations support Inverse ARP. INARP
enables address resolution for frame relay interfaces, which allows for
discovery of the IP address of the remote end of the virtual circuit.
ARPINARP for your frame relay interfaces. ARPINARP enables both ARP
and Inverse ARP.
NONE to specify no address resolution scheme for this interface
X.25 BFE DDN
PROBE to enable HP Probe on the interface
ARP PROBE to enable both ARP and HP Probe on the interface
ATMARP to enable ATMARP on the interface (for ATM SVCs configured for
classical IP [RFC 1577] and ATM PVCs only)
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.15
Vista de pagina 247
1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 361 362

Comentarios a estos manuales

Sin comentarios