Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 265

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 362
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 264
Site Manager Parameters
117356-E Rev 00
A-25
Parameter: RIP Maximum Equal Cost Paths
Path: Configuration Manager > Protocols > IP > Global
Default: 1
Options: 1 to 5
Function: Specifies the maximum number of equal-cost paths allowed for a network
stored in the routing table by RIP.
Instructions: If you enabled equal-cost multipath support on the router, specify a value from 2
to 5.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.17
Parameter: Multiple Nexthop Calculation Method
Path: Configuration Manager > Protocols > IP > Global
Default: Disable
Options: Disable
|
Round Robin
|
Source Destination Hash
|
Destination Hash
Function: Enables and disables equal-cost multipath support for RIP and OSPF and
specifies the method that IP uses to choose the next hop when more than one is
available. Three methods are available: round-robin selection, selection based
on the source addresses (IP forwards all packets with the same source address to
the same next hop), and selection based on the source and destination address
(IP forwards all packets with the same source and destination address to the
same next hop).
Instructions: Configure RIP and OSPF to support equal-cost routes to the same destination.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.18
Parameter: IP OSPF Maximum Path
Path: Configuration Manager > Protocols > IP > OSPF/MOSPF > Global
Default: 1
Options: 1 to 5
Function: Specifies the maximum number of equal-cost paths allowed for a network
stored in the routing table by OSPF.
Instructions: If you enabled equal-cost multipath support on the router, specify a value from 2
to 5.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.3.1.18
Vista de pagina 264
1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 361 362

Comentarios a estos manuales

Sin comentarios