Avaya Configuring IP, ARP, RIP, and OSPF Services Manual de usuario Pagina 246

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 362
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 245
Configuring IP, ARP, RIP, and OSPF Services
A-6
117356-E Rev 00
Parameter: MTU Discovery
Path: Configuration Manager > Protocols > IP > Interfaces
Default: Disabled
Options: Enabled
|
Disabled
Function: Specifies whether the reply MTU option (option 11 in RFC 1063) is enabled on
this interface. When the option is enabled, this interface responds to probe
MTUs (option 12 in RFC 1063). A probe MTU requests the maximum
transmission unit (MTU) of all networks that an IP datagram must traverse from
source to destination. By enabling this interface to respond to probe MTUs, you
eliminate transit fragmentation and destination reassembly for datagrams
destined for this interface and, therefore, decrease network load.
Instructions: Select Enabled to enable the reply MTU option on this interface; select Disabled
to disable the option on this interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.12
Parameter: AMR
Path: Configuration Manager > Protocols > IP > Interfaces
Default: Disabled
Options: Enabled
|
Disabled
Function: Specifies whether this interface generates Internet Control Message Protocol
(ICMP) address-mask reply messages in response to valid address-mask request
messages. The interface generates ICMP address-mask reply messages in
compliance with the relevant sections of RFCs 950 and 1009.
Instructions: Select Enabled to enable ICMP address-mask reply message generation on this
interface. Select Disabled to disable ICMP address-mask reply message
generation on this interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.13
Vista de pagina 245
1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 361 362

Comentarios a estos manuales

Sin comentarios