
Configuring IP, ARP, RIP, and OSPF Services
A-28
117356-E Rev 00
Parameter: Cost
Path: Configuration Manager > Protocols > IP > Static Routes > Add
Default: 1
Options: 1 to the value of the RIP Diameter parameter (maximum 127)
Function: Specifies the number of router hops that a datagram can traverse before
reaching the destination IP address. The IP router uses the cost value when
determining the best route for a datagram to follow.
Instructions: Enter the number of router hops.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.5
Parameter: Next Hop Addr
Path: Configuration Manager > Protocols > IP > Static Routes
Default: 0.0.0.0
Options: Any valid IP address
Function: Specifies the IP address of the next-hop router. Defines a black hole route for a
supernet.
Instructions: Enter the IP address in dotted-decimal notation. To configure a black hole
static route, enter 255.255.255.255. If you are configuring a static route to an
unnumbered interface, enter 0.0.0.0.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.6
Parameter: Next Hop Mask
Path: Configuration Manager > Protocols > IP > Static Routes
Default: 0.0.0.0
Options: Any valid subnet mask address
Function: Specifies the subnet mask of the next-hop router. This parameter also defines a
black hole route for a supernet.
Instructions: Enter the subnet mask in dotted-decimal notation. To configure a black hole
static route, enter 255.255.255.255. If you are configuring a static route to an
unnumbered interface, enter 0.0.0.0.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.7
Comentarios a estos manuales