
Routing Policy Parameters
117356-E Rev 00
B-9
Parameter: Action
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Announce
Policies
Path: Configuration Manager > Protocols > IP > Policy Filters > OSPF > Announce
Policies
Default: Announce
Options: Announce
|
Ignore
Function: Specifies whether or not to advertise a route that matches this policy.
Instructions: To advertise the route, specify Announce. To drop the route, specify Ignore.
MIB Object ID: RIP: 1.3.6.1.4.1.18.3.5.3.2.6.2.1.6
MIB Object ID: OSPF: 1.3.6.1.4.1.18.3.5.3.2.6.4.1.6
Parameter: Rule Precedence
Path: Configuration Manager > Protocols > IP > Policy Filters > RIP > Announce
Policies
Path: Configuration Manager > Protocols > IP > Policy Filters > OSPF > Announce
Policies
Default: 0
Options: A metric value
Function: Specifies a metric value to be used to compare this policy with other policies
that a route may match. A policy with a higher metric takes precedence over a
policy with a lower metric. In case of a tie, the protocol uses an internal index
value assigned to the policy by IP software. (In general, the index value is
indicated by the position of the policy in the Site Manager window -- the last
policy in the window has the highest index value.)
Instructions: Use this parameter to assign precedence to policies that match the same route.
MIB Object ID: RIP: 1.3.6.1.4.1.18.3.5.3.2.6.2.1.7
MIB Object ID: OSPF: 1.3.6.1.4.1.18.3.5.3.2.6.4.1.7
Comentarios a estos manuales