
Configuring IP, ARP, RIP, and OSPF Services
5-14
117356-E Rev 00
Receiving RIP Updates on an Interface
By default, RIP listens for routing updates on every interface on which it is
enabled.
You can use the BCC or Site Manager to disable and reenable this feature as
required.
Using the BCC
To specify whether RIP listens for routing updates, navigate to a RIP interface
prompt (for example,
box; eth 2/2; ip/2.2.2.2/255.255.0.0; rip
) and enter:
listen
<state>
state
is one of the following:
enabled
(default)
disabled
For example, the following command causes RIP to stop listening for updates on
IP interface 2.2.2.2:
rip/2.2.2.2#
listen disabled
rip/2.2.2.2#
Note:
If you enable this feature, a configured policy can still prohibit the
interface from updating its internal routing table.
Comentarios a estos manuales