
Configuring Dial Services
1-42 114062 Rev. B
4. Enter the name and CHAP secret of the remote router.
The CHAP secret must be the same for routers on both sides of the circuit.
The Caller Name parameter identifies a remote router. Do not confuse this
parameter with the CHAP Local Name parameter, which identifies the local
router, that is, the router you are currently configuring.
5. Click on OK.
Site Manager displays the Local Circuit List window (Figure
1-35), which
lists the demand, primary, or bandwidth circuits that you have configured.
Figure 1-35. Local Circuit List Window
6.
Highlight the local circuit that the router should activate when it receives
a call from the remote router (specified in the Caller Name parameter).
7. Click on OK.
You return to the caller resolution table window. When you select a caller
name in the window, the parameters display the caller’s information.
8. Click on Done when you finish adding table entries.
Site Manager: Caller Name parameter: page A-103
Site Manager: CHAP Secret parameter: page A-103
Site Manager: Local Circuit parameter: page A-104
Comentarios a estos manuales