
114062 Rev. B 11-1
Chapter 11
Customizing Bandwidth-on-Demand Circuits
This chapter describes how to modify the bandwidth-on demand configuration for
your network.
To enable bandwidth-on-demand service, you can do the following:
• Designate a single leased circuit or leased multilink circuit as a
bandwidth-on-demand circuit
• Associate a dial-on-demand circuit with a bandwidth-on-demand pool
If any of these circuits becomes congested, the router provides up to 29 additional
dial-up circuits to relieve congestion, for a total of 30 circuits. You should have
already set up a bandwidth-on-demand pool and circuit in Chapter 1.
T
able 11-1 lists the terminology that Site Manager and this manual use to refer to
circuits in a bandwidth-on-demand configuration.
Table 11-1. Terminology for Bandwidth-on-Demand Service
Type of Circuit Referred to As
Leased circuit
Leased multilink circuit
Bandwidth circuit
You designate a leased circuit as a bandwidth circuit to
enable bandwidth-on-demand service.
Dial-on-demand circuit Demand circuit
This is a demand circuit for which you can provide
bandwidth-on-demand service. You
do not designate this
as a bandwidth circuit.
Dial-up circuit that helps the
congested leased circuit
Dial-up or secondary circuit
Comentarios a estos manuales