
Configuring Dial Services
8-12 114062 Rev. B
Modifying ISDN Configurations
This section describes how to modify ISDN configurations. You cannot modify
the BRI or PRI port application. You must remove the interface and repeat the
configuration procedure. To delete these interfaces, refer to “Remo
ving BRI and
PRI from the Router” on page 8-28.
Modifying BRI Signaling over the D Channel
The BRI Interface Configuration window defines the signaling over the
D channel. In most cases, the defaults for BRI will work for your network;
however, you can edit the parameters.
To edit the BRI:
1. Begin at the Configuration Manager window.
2. Click on a configured ISDN connector.
Site Manager displays the ISDN Dialup window (Figure
8-6).
Figure 8-6. ISDN Dialup Window
3.
Click on Edit D Chan.
Site Manager displays the BRI Interface Configuration window (Figure
8-7).
Comentarios a estos manuales