
Configuring Dial Services
A-70 114062 Rev. B
Frame Relay PVC Parameters (Demand and Dial Backup)
You cannot enter values for the following Frame Relay PVC parameters: Node
Protection Key, Encrypt Enable, LTSS Name, LTSS Value, and MEK Change.
These parameters are available only if you enable data encryption. For
information about encryption, refer to Configuring Data Encryption Services.
Parameter: DLCI Number
Path: Dialup > Backup Circuits > Frame Relay > FR Primary Interface Definition >
Backup Def. > FR Backup Interface > Services > Frame Relay Backup Service
List > PVCs > Add > Frame Relay PVC Add
Default: None
Options: The Frame Relay switch provider assigns DLCI numbers. These assigned
numbers are valid options.
Valid DLCI numbers vary based on the Frame Relay address length. The DLCI
numbers that the switch provider assigns are generally in the following ranges:
2 byte -- 16 to 1007
3 byte -- 1024 to 6451
4 byte -- 131,072 to 8,257,535
Function: Specifies the PVC identification number that the Frame Relay network uses to
direct data. If you are running IP over Frame Relay, the router uses this number
as the MAC address for an adjacent host. Refer to Configuring IP Services for
more information about adjacent hosts.
Instructions: Enter the decimal number that the Frame Relay provider assigns.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.9.2.1.4
Comentarios a estos manuales