
Configuring Dial Services
B-22 114062 Rev. B
Outgoing Phone List
From the Primary Circuit Definition window, click on Phone Out to open the
Outgoing Phone List window.
Path: Outgoing Phone List > Phone Number window
Caller Resolution Table Configuration
Router 1, the master router, does not require a caller resolution table. Router 1
initiates calls to Router 2, it does not receive them; therefore, Router 1 does not
need to verify Router 2’s identity. In contrast, Router 1 must have a CHAP name
and secret that it places in the call setup message to identify itself to Router 2.
Router 2, the slave router, requires a table entry. Router 2 receives calls from
Router 1 and must identify the incoming caller. After configuring the backup
circuits, you can configure the caller resolution table.
Path: Dialup > Caller Resolution Table > Caller Name and Secret/Password
Click on OK. Site Manager displays the Local Circuit List window.
Table B-30. Outgoing Phone List Parameter
Parameter
Router 1
(S131)
Router 2
(S12)
Phone Number 4363333
(Do not use hyphens or other
nonnumeric characters.)
4364444
(Do not use hyphens or other
nonnumeric characters.)
Note: The ISDN Numbering Plan and ISDN Numbering Type parameters
default to the correct values based on the switch type you configured. Do not
change these parameters unless you receive explicit instructions from your
service provider.
Table B-31. Caller Resolution Table Parameters (Router 2 only)
Parameter
Router 1
(S131)
Router 2
(S12)
Caller Name N/A ASN
CHAP Secret N/A ISDN
Comentarios a estos manuales