
Getting Started
114062 Rev. B 1-11
Creating Line Pools with ISDN Lines
Before creating a pool with ISDN lines, you need to select a port and designate it
as a BRI or PRI interface. Refer to the appropriate section for instructions:
•“Confi
guring BRI Lines”
•“Confi
guring PRI Lines” on page 1-12
Configuring BRI Lines
ISDN/BRI Net Modules are available only on the Access Node (AN
®
), Access
Stack Node (ASN™), Access Node Hub (ANH™), and Access Remote Node
(ARN™) hardware platforms. To configure BRI lines:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Click on an ISDN connector.
Site Manager displays the Port Application window (Figure
1-8).
Figure 1-8. Port Application Window
3.
Accept the default, Dialup 2B+D, and click on OK.
You return to the Configuration Manager window.
4. Repeat Steps 1 through 3 for each BRI line you want in the pool.
5. Go to “Adding ISDN Lines to a Pool” on page 1-16.
Site Manager: Port Application Mode parameter: page A-15
Comentarios a estos manuales