Avaya Configuring Dial Services Manual de usuario Pagina 313

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 312
Dial Service Parameters
114062 Rev. B A-43
Parameter: UpTime Term. Reset
Path: Demand Circuits: Dialup > Demand Circuits > Demand Pools >
PPP or FR Circuits > PPP or FR Demand Circuits
Backup Circuits: Dialup > Backup Circuits > PPP or Frame Relay > Primary
Circuit Definition or FR Primary Interface Definition
Default: 60 minutes
Range: 1 to 999,999 minutes
Function: Determines the amount of time the router waits before making the demand
circuit available again after an uptime termination (Max UpT
ime Termination
parameter). The circuit is not established at this point, but the next time the
router receives data, the circuit will be available and the router can activate it.
The router invokes this timer only after an invoking the UpTime Termination
parameter.
Instructions: Enter the time period that the router should wait before making the circuit
available again. You must enter a value for this parameter if you configured the
Max UpTime Termination parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.5.1.34
Parameter: Minimum Call Duration
Path: Demand Circuits: Dialup > Demand Circuits > Demand Pools >
PPP or FR Circuits > PPP or FR Demand Circuits
Default: 60 seconds
Range: 10 to 2,147,483,647
Function: Specifies the minimum amount of time that the connection remains active
regardless of whether there is data traffic.
Instructions: Enter the minimum amount of time the connection should remain active. For
dial optimized routing circuits, this timer should allow enough time to send all
routing updates to the remote nodes in the network.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.5.1.45
Vista de pagina 312
1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 427 428

Comentarios a estos manuales

Sin comentarios