
Customizing Demand Circuits
114062 Rev. B 9-17
Figure 9-13. Enter a Demand Pool Window
4.
Enter the demand pool ID that this group should use.
5. Enter the number of circuits you want in the group.
6. Click on OK.
7. Go to the next section, “Caller Resolution Information for Demand
Circuit Groups.”
Caller Resolution Information for Demand Circuit Groups
After you specify the demand pool ID and the number of circuits for a demand
circuit group, Site Manager displays the Caller Resolution Info window
(Figure
9-14). You use this window to enter the CHAP name or PAP ID of the
remote routers associated with this demand circuit group. When a remote call
comes in, the router activates a circuit from the specified circuit group.
Site Manager prompts you for this information because demand circuit groups
cannot initiate calls. Site Manager ensures that you make an entry for the remote
router in the caller resolution table so that the local router, configured with the
demand circuit group, can accept incoming calls.
Site Manager: Pool ID parameter: page A-49
Site Manager: Number of Circuits parameter: page A-49
Comentarios a estos manuales