Avaya Configuring Dial Services Manual de usuario Pagina 322

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 321
Configuring Dial Services
A-52 114062 Rev. B
Demand Circuit Group Protocol Parameters
Parameter: IP Enable
Path: Dialup > Demand Circuit Groups > Demand Circuit Groups
Default: Disable
Options: Enable
| Disable
Function: Enables or disables IP for this interface.
Instructions: Select Enable to enable IP for this interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.12.1.5
Parameter: Associated IP Address
Path: Dialup > Demand Circuit Groups > Demand Circuit Groups
Default: None
Options: Any valid IP address
Function: Specifies an address that IP uses when sending a packet. All circuits in the
demand circuit group use this address, which specifies a numbered interface on
the router. IP routing protocols use the numbered address to advertise the local
router to remote routers. For more information about associated IP addresses,
refer to Configuring IP Services.
Instructions: Enter the address of any numbered interface on the router. If you are running
RIP over the unnumbered interface, and are using a subnet address as the
associated address, the local and remote associated addresses should have the
same network number.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.12.1.6
Vista de pagina 321
1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 427 428

Comentarios a estos manuales

Sin comentarios