
Configuring Dial Services
1-2
114062 Rev. B
• Instructions for modifying the default configuration in Chapter
1.
These instructions are in Chapters 8 through 13. Most of the instructions
assume that you have read Chapter
1 and explain how to modify the
configuration.
In the procedures, any step that instructs you to set a parameter value is
followed by a box that includes the Site Manager parameter and the location
of the parameter description in Appendix A. To read more about the
parameter before specifying a value, refer to the specified page.
• Appendixes that include parameter descriptions, configuration examples,
parameter default tables, ISDN ordering information, and a list of AT modem
initialization commands.
The names of the dial services are sometimes abbreviated in this manual.
T
able 1-1 lists the full and abbreviated names of each dial service.
Before You Begin
Before you configure a dial service, you should have done the following:
• Installed the router.
• Installed either ISDN or modem lines.
• Ordered Integrated Services Digital Network (ISDN) service (if applicable)
and received the information for setting up ISDN configurations (for example,
switch type and phone numbers). Refer to Appendix D for information on
ordering ISDN lines in the United States.
• Ordered and configured external modems (if applicable).
• Decided whether to use the Challenge Handshake Authentication Protocol
(CHAP) or the Password Authentication Protocol (PAP) for Point-to-Point
Protocol (PPP) connections.
Table 1-1. Dial Service Names
Full Name Abbreviated Name
Dial-on-demand Demand
Dial backup Backup
Bandwidth-on-demand Bandwidth
Comentarios a estos manuales