
Configuring Dial Services
1-32 114062 Rev. B
Specifying the Authentication Protocol
For network security, the router must identify itself in the call setup message that
it sends to the remote router. The authentication protocols, CHAP and PAP, enable
the identification process. CHAP is the default protocol.
All lines in a pool must use the same authentication protocol.
To specify the CHAP information for the local router:
1. Scroll down the Bandwidth-on-Demand Circuit Definition window to the
CHAP parameters.
2. Enter values for the CHAP Local Name and CHAP Secret parameters.
The CHAP Local Name must be unique, but the CHAP Secret must be the
same on both sides of the connection.
3. Do one of the following:
-- If you have ISDN lines in the pool, go to “C
reating an Outgoing Phone
List” on page 1-36.
-- If you have only Raise D TR lines in the pool, click on Done in the
Bandwidth-on-Demand Circuit Definition window and go to “Setting
Up
the Caller Resolution Table” on page 1-40.
Site Manager: CHAP Local Name parameter: page A-37
Site Manager: CHAP Secret parameter: page A-38
Comentarios a estos manuales