Avaya Configuring Dial Services Manual de usuario Pagina 206

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 205
Configuring Dial Services
9-12 114062 Rev. B
Bandwidth-on-Demand Service for Demand Lines (PPP only)
If the demand line becomes congested, the router can provide an additional 29
dial-up lines to reduce the congestion. In Chapter 1, you had an opportunity to
enable bandwidth-on-demand service for a demand circuit. Refer to that chapter
for instructions. To modify the bandwidth-on-demand parameters, refer to
Chapter 11.
Adding Protocols to PPP Demand Circuits
In Chapter 1, you added IP to a PPP demand circuit. To add other protocols:
1. Begin at the Configuration Manager window.
2. Select Dialup > Demand Circuits.
Site Manager displays the Demand Pools window (refer to Figure
9-1).
3. Click on PPP Circuits.
Site Manager displays the PPP Demand Circuits window (refer to
Figure 1-17).
4. Select Protocols > Add/Delete in the top left corner of the window.
Site Manager displays the Select Protocols window (refer to Figure
9-8).
5. Select one or more protocols for the demand circuit.
For each protocol you select, Site Manager displays windows that prompt you
for required information. Consult the appropriate protocol manual.
6. Click on OK.
You return to the PPP Demand Circuits window.
7. Click on Done.
Note: You cannot configure protocol prioritization for demand circuits
running PPP multilink. Protocol prioritization modifies the order in which
packets are sent over the line, which could change the multilink-assigned order
of packets and cause problems with the data.
Vista de pagina 205
1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 427 428

Comentarios a estos manuales

Sin comentarios