Avaya Configuring Dial Services Manual de usuario Pagina 54

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 53
Configuring Dial Services
1-24 114062 Rev. B
4. Enter an IP adjacent host address and click on OK.
Site Manager displays the IP Adjacent Host Route window.
5. Click on OK to accept the defaults.
You return to the PPP Demand Circuits window (refer to Figure
1-18).
6. Do one of the following:
-- If you have ISDN lines in the pool, go to “C
reating an Outgoing Phone
List” on page 1-36.
-- If you have only Raise DTR lines in the pool, click on Done in the PPP
Demand Circuits window and go to “Setting
Up the Caller Resolution
Table” on page 1-40.
Site Manager: IP Adjacent Host parameter; see
Configuring IP Services
Note: You cannot configure protocol prioritization for demand circuits
running PPP multilink. Protocol prioritization modifies the order in which
packets are sent across the line. This could change the multilink-assigned order
of packets and cause problems with the data.
Vista de pagina 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 427 428

Comentarios a estos manuales

Sin comentarios