
Configuring Dial Services
8-14 114062 Rev. B
Modifying the MCT1 and MCE1 Port Configurations
The defaults for the port parameters work for most configurations; however, you
can modify the physical interface of the MCT1 and MCE1 ports, as follows:
1. Begin at the Configuration Manager window.
2. Click on an MCT1 or MCE1 connector.
Site Manager displays the PRI Logical Lines window (Figure
8-8).
Figure 8-8. PRI Logical Lines Window
3.
Click on Port Details.
Site Manager displays the Port Parameters window (refer to Figure 1-10).
4. Modify the parameters according to the descriptions in
Configuring WAN Line Services.
5. Click on OK.
You return to the PRI Logical Lines window.
6. Click on Apply to save the changes.
7. Click on Done.
Comentarios a estos manuales