
114062 Rev. B B-1
Appendix B
Configuration Examples
This appendix provides examples for configuring the following applications:
• Dial-on-demand using V.25bis signaling
• Dial-on-demand over an ISDN network
• Dial backup using Raise DTR signaling with PPP and Bay Networks Standard
over the primary line
• Dial backup over an ISDN network with PPP, Bay Networks Standard, and
Frame Relay over the primary line
These examples include parameters whose defaults you need to change for proper
configuration. A sample network illustration shows each type of dial
configuration. Each illustration is followed by a set of tables that include the
Site Manager window path to access the parameters and the correct parameter
values. All paths assume that you begin at the Configuration Manager window.
The ISDN examples (page
B-6 and page B-18) assume the following:
• All BRI connections use a National ISDN 1 (NI1) switch.
• There is no incoming call filtering.
• Sending complete IEs are not used for call setup.
• The adaption rate is 64 Kb/s.
• CHAP is the PPP authentication protocol.
• IP is the only LAN protocol configured.
• The Ethernet segments shown in the network illustration are not configured.
• Only one phone number and SPID are used. (BRI lines usually have two
phone numbers and SPIDs.)
Comentarios a estos manuales