Avaya Configuring Dial Services Manual de usuario Pagina 399

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 428
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 398
Configuration Examples
114062 Rev. B B-23
Path: Caller Name and Secret/Password > Local Circuit List
The primary circuits are listed in the Local Circuit List window. Choose the
primary circuit you created earlier.
Local Phone Number Configuration
Finally, configure each router’s phone number.
Path: Dialup > Local Phone Numbers
Site Manager displays the ISDN Local Phone Lines window. Click on Local
Phones. Site Manager displays the ISDN Local Phone Numbers window.
Path: ISDN Local Phone Numbers > Phone Number
Configuring Dial Backup with Standard or Frame Relay
If the primary circuit uses Standard as the WAN protocol, you must configure a
unique value for the MAC Address parameter of the primary IP interface. The
router then uses this address as the value of the MAC Address parameter in the IP
adjacent host entry for the remote router. Routers on each end of the connection
require an IP adjacent host entry that includes the other router’s MAC address.
If the primary circuit uses Frame Relay (in direct mode, using A-bit notification)
as the WAN protocol, you do not need to configure the MAC address of the
primary IP interface. However, you still need to configure an IP adjacent host
entry for both routers.
Table B-32. Local Phone Numbers Parameters
Parameter
Router 1
(S131)
Router 2
(S12)
Directory Number 4364444 4363333
SPID 50843644440000 50843633330000
Note: A SPID is required for a BRI line using an NI1 switch.
Vista de pagina 398
1 2 ... 394 395 396 397 398 399 400 401 402 403 404 ... 427 428

Comentarios a estos manuales

Sin comentarios