
Dial Service Parameters
114062 Rev. B A-59
Frame Relay Primary Interface Definition Parameters (Dial Backup)
Parameter: Backup Pool ID
Path: Dialup > Backup Circuits > Frame Relay > FR Primary Interface Definition
Default: None
Range: 1 to 255
Function: Identifies the backup pool for the primary circuit.
Instructions: Enter the ID number of the backup pool this circuit should use.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.5.1.5
Parameter: Primary Down Time
Path: Dialup > Backup Circuits > Frame Relay > FR Primary Interface Definition
Default: 5 minutes
Range: 1 to 999,999 minutes
Function: Specifies the amount of time the router waits before activating a backup
connection. This parameter works on a slot-by-slot basis. While the router waits
for the first connection, a backup connection on another slot can activate, in
which case, the router resets this timer on all other slots.
Instructions: Enter the amount of time the router should wait before activating a backup
connection.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.5.1.17
Parameter: Use Backup Interface Filters
Path: Dialup > Backup Circuits > Frame Relay > FR Primary Interface Definition
Default: Disabled
Options: Enabled
| Disabled
Function: Enables the routers to filter unwanted data from going across the backup circuit.
This parameter is configurable only if the interface type is primary/shared.
Instructions: Select Enable to use filters; otherwise, accept the default.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.9.1.1.34
Comentarios a estos manuales