
Configuring Dial Services
8-4 114062 Rev. B
Modifying the WAN Serial Interface Type and Line Media Type
You should have already configured the WAN serial interface type and line media
type in Chapter 1.
To modify the WAN serial interface type and the line media type:
1. Begin at the Configuration Manager window.
2. Click on the COM connector whose interface you want to change.
The connector name should have a D, B, or W next to it.
Site Manager displays the Edit Connector window (Figure
8-2).
Figure 8-2. Edit Connector Window
3.
Click on Edit Line.
Site Manager displays the Edit SYNC Parameters window.
4. In the Edit SYNC Parameters window, find and modify the following
parameters:
• WAN Serial Interface Type
Change this value from the default, Sync, to Async if you want to use
asynchronous PPP across your dial-up lines. If you are already using
asynchronous PPP, you can change the type from Async to Sync.
Remember that for the BLN and BCN, this parameter is available only on
the Octal Sync Link Module.
Site Manager: WAN Serial Interface Type parameter: page A-4
Comentarios a estos manuales