Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario descargar pdf (Pagina 217)

Site Manager Parameters

308628-14.00 Rev 00

A-41

Parameter: Forward Cache Size

Path: Configuration Manager > Protocols > IP > Interfaces

Default: 128 entries

Options: 64-entry minimum; no maximum

Function: Specifies the maximum number of entries allowed in the forwarding table at

one time.

Instructions: Specify a forwarding table size for each interface. This parameter controls the

number of destinations that are cached in the forwarding table on this receiving

interface. When this interface receives an IP packet, the router looks up the

destination in the forwarding table. Therefore, an interface that receives

packets for a large number of destinations may benefit from a larger

forwarding table. The larger the number of entries, the more likely it is that the

destination will already be in the forwarding table and the faster the route

lookups will be for those destinations. Configuring a forwarding table size that

is larger than necessary reduces the total amount of memory usable by other

applications. Configuring a routing table too small can affect overall router

performance. A check of the number of cache hits and misses will help

determine the optimal size of the forwarding table. For debugging purposes, if

you see the wfIpInterfaceCacheMisses statistic going up at an alarming rate,

you should consider increasing the table size. However, an occasional cache

miss does not warrant an increase in table size.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.104

Parameter: Enable Security

Path: Configuration Manager > Protocols > IP > Interfaces

Default: Disable

Options: Enable

Disable

Function: Specifies whether Revised IP Security Option (RIPSO) is enabled for the

interface.

Instructions: If you do not support RIPSO on your network, simply accept the default

setting, Disable. If you are configuring RISPO support, set this parameter to

Enable. Once you set this parameter to Enable, you can access the rest of the

RIPSO parameters. If you do not enable this parameter, Site Manager does not

activate the RIPSO parameters.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.28

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 307 308

Sin comentarios

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 217