
Configuring IP Exterior Gateway Protocols (BGP and EGP)
7-12
308628-14.00 Rev 00
Using Site Manager
Table 7-4. BCC Definition Parameters for BGP Announce Policies
Parameter Values Function
state enabled (default)
disabled
Enables or disables this policy
action ignore (default)
propagate
Specifies whether or not to advertise a route that
matches this policy
precedence 0 (default) to any
metric value
Specifies a metric value to be used to compare
this policy with other policies that a route may
match. A policy with a higher metric takes
precedence over a policy with a lower metric. In
case of a tie, the protocol uses an internal index
value assigned to the policy by IP software. (In
general, the index value is indicated by the
position of the policy in the Site Manager display
-- the last policy in the display has the highest
index value.)
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
Policy Filters
. The Policy Filters menu opens.
4. Choose
BGP-4
. The BGP-4 menu opens.
5. Choose
Announce Policies
. The BGP4 Announce Policy Filters
window opens.
6. Click on
Add
. The BGP4 Announce IP Policy Filter
Configuration window opens.
(continued)
Comentarios a estos manuales