Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 308
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
308628-14.00 Rev 00
xv
Preface
Routers at the borders or edges of autonomous systems are called gateways. These
gateways use exterior gateway protocols to exchange reachability information
with each other and route packets between routing domains. This guide describes
how to configure and use the IP Border Gateway Protocol (BGP) and the Exterior
Gateway Protocol (EGP).
You can use the Bay Command Console (BCC
) or Site Manager to configure IP,
including BGP and EGP, on a router. In this guide, you will find instructions for
using both the BCC and Site Manager.
Before You Begin
Before using this guide, you must complete the following procedures. For a new
router:
Install the router (see the installation guide that came with your router).
Connect the router to the network and create a pilot configuration file (see
Quick-Starting Routers
,
Configuring BayStack Remote Access
, or
Connecting
ASN Routers to a Network)
.
Make sure that you are running the latest version of Nortel Networks
BayRS
and Site Manager software. For information about upgrading BayRS and Site
Manager, see the upgrading guide for your version of BayRS.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 307 308

Comentarios a estos manuales

Sin comentarios