Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario descargar pdf (Pagina 206)

Configuring IP Exterior Gateway Protocols (BGP and EGP)

A-30

308628-14.00 Rev 00

IP Interface Parameters

Parameter: Unnumbered Associated Address

Path: Select IP from the Select Protocols window and click on OK.

Default: None

Options: Any valid IP address

Function: Specifies an address that IP uses when sourcing a packet. RIP uses this address

to make decisions about advertising subnets over the unnumbered interface. RIP

advertises subnets over the unnumbered interface if the subnets have the same

mask as the associated address.

Instructions: Specify the address of any numbered interface on the router. If you are running

RIP over the unnumbered interface and if you are using a subnet address as the

associated address, the local and remote associated addresses should have the

same network number. If you configure local and remote associated addresses

using different network numbers, you must use RIP2 mode.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.110

Parameter: Enable

Path: Configuration Manager > Protocols > IP > Interfaces

Default: Enable

Options: Enable

Disable

Function: Enables or disables IP routing on this interface.

Instructions: Set to Disable to disable IP routing over this circuit.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.2

Parameter: Mask

Path: Configuration Manager > Protocols > IP > Interfaces

Default: You specified the subnet mask when you added IP to the circuit.

Options: Depend on the class of the network to which the interface connects

Function: Specifies the network and subnetwork portion of the 32-bit IP address.

Instructions: Enter the subnet mask in dotted-decimal notation.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.24.1.6

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 307 308

Sin comentarios

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Manual de usuario Pagina 206