Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 88)

88 BCM 5.0 trunk module configuration

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

Variable definitions

Provisioning module lines and loops

Configure the module lines and loops for your BCM system.

Prerequisites

• Configure the trunk module parameters. For more information, see

Configuring the trunk module parameters (page 86).

Procedure steps

Step Action

1 Select Configuration > Resources > Telephony Resources.

2 On the Modules panel, click the trunk module entry that you want to view.

The panel that appears depends on the type of module that is selected.

3 Provision the lines, virtual channels, and loops for your module.

• The Provision Line tab panel is used for all trunks except DPNSS and

BRI loops.

• The DPNSS module shows the Provision Virtual Channels tab panel.

• BRI loops require an extra step, so the Provision Loops tab panel

appears after a BRI module is selected.

--End--

Variable definitions

Variable Value

Service Type Foreign Exchange Define the applicable services for the protocol defined on the

Module record.

Translation Mode Define how the incoming digits get mapped to line numbers

(target lines or DISA/AUTO DNs) within the system.

Translate All Calls To Enter the appropriate information for the mode chosen.

Variable Value

Provision Lines tab

Line <line number> This is a list of the lines assigned to the module.

Provisioned <check box> If the check box is selected beside a line, that line is available for

call traffic.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 223 224

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 88