Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 107)

Dial-up resources configuration 107

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

Variable definitions

Variable Description

Enable ISDN dial-in Enable or disable ISDN dial-in.

Default: disabled

Connection State: This is a table that shows the current dial-in state if connected.

Note: There is a maximum of two entries in this table (as there are two ISDN channels). This table will

display the ISDN channels that are available for ISDN dial in. If any channels are being used for ISDN

dial-out (either Automatic or manual) then this channel will not be available for ISDN dial-in, and will not

appear in this table.

User Displays the user that is currently dialed in.

<read-only>

Local IP Address Displays the local IP address assigned to the dial-in connection.

<read-only>

Remote IP Address Displays the remote IP address of the dial-in connection.

<read-only>

Callback Displays if callback is enabled for this dial-in connection.

<read-only>

Status The status of the dial-in connection.

<read-only>

ISDN Callback Settings

Callback retries The number of attempts made by the BCM to dial-out to the remote

end during callback.

<1-10>

Default: 3

Callback retry interval (s) Interval for successive connection attempts for dial-out during

callback.

<0-360>

Default: 60 seconds

PPP Configuration. These parameters are passed to PPP stack to manage the PPP connection.

Idle timeout (s) Idle time period after which PPP will terminate the PPP connection.

Default: 1800 seconds

Maximum receive unit The maximum size of the packets that can be received.

<128-1500>

Default: 500

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 223 224

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 107