Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 82)

82 BCM450 MBM and legacy Norstar configuration

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

Variable definitions

Deconfiguring MBMs and Norstar modules

Deconfiguring a previously configured device removes assigned resources to

that device. However, target lines will remain assigned to the same bus. If that

bus is then re-configured with DNs, those target lines will be assigned to those

DNs. Refer to “Directory numbers” on page 16 for more information.

Prerequisites

• If a currently configured MBM is changed to Empty/None or changed to a

different MBM type, all associated provisioned resources are freed and

that MBM is rendered deconfigured and inoperable.

• The line numbers against a T-interface loop cannot be deleted. To remove

the line numbers assigned to a BRI, you must remove the BRI device.

Procedure steps

Step Action

1 Select Configuration > Resources > Telephony Resources.

2 In the Modules section, select the MBM or legacy Norstar module to

deconfigure.

Variable Value

Module type This read-only value is the type of module allocated to this

resource. In this case the value is the type of MBM.

Start DN The lowest DN in the range of DNs assigned to your resource.

The DNs in the range can be consecutive or non-consecutive.

Public received digits/OLI The public received digits/OLI (outgoing line identification) are

the digits that display on the telephone called from this DN over

the public network. This number is usually the same as the DN.

Private received digits/OLI The private received digits/OLI (outgoing line identification) are

the digits that display on the telephone called from this DN over

the private network. This number is usually the same as the DN.

Assign target lines Select this checkbox to assign target lines to your DNs.

Start Line The first line number in the sequence of consecutive lines

assigned to your MBM.

DIP The DIP switch configuration for the installed MBM. Nortel

recommends that you leave the MBM dip switches in the default

position (all set to on).

This variable only applies to an MBM installed in the expansion

unit.The DIP switches must be set in an expansion unit.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 223 224

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 82