
BCM 5.0 trunk module configuration 87
Nortel Business Communications Manager 5.0
Configuration — System
NN40170-501 02.04 Standard
September 2009
Copyright © 2009, Nortel Networks
Procedure steps
Step Action
1 Select Configuration > Resources > Telephony Resources.
2 On the Modules panel, click the trunk module entry that you want to view.
3 On the Trunk Module Parameters tab, review the settings to ensure they
support the type of line function provided from the Central Office (CO).
--End--
Configuring call-by-call service selection
Configure the PRI Call-by-call Service Selection, which is region-specific to
North America, for a DTM set to a PRI Module type.
Prerequisites
• Applies to modules that support T1, PRI, or DASS2.
• Configure the trunk module parameters. For more information, see
Configuring the trunk module parameters (page 86).
Procedure steps
Step Action
1 Select Configuration > Resources > Telephony Resources.
2 On the Modules panel, click the trunk module entry that you want to view.
3 From the Call-by-Call Service Selection tab, set the attributes.
--End--
Comentarios a estos manuales