Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 59)

BCM 5.0 configuration with Business Element Manager 59

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

2 Select the Service Access Points tab.

The Service Access Points tab appears.

3 Click Add.

The Add Service Access points dialog box appears.

4 Configure the Add Service Access Points attributes.

5 Click OK.

--End--

Variable definitions

Deleting service access points

You can delete service access points.

Procedure steps

Step Action

1 Select Configuration > Administrator Access > SNMP.

2 Select the Service Access Points tab.

The Service Access Points tab appears.

3 In the Service Access Points table select a service access point.

Variable Value

User name Enter the name of the user associated with the service access

point.

Authentication Protocol Select the authentication protocol. Options are: None, MD5,

SHA.

Type of Access Select the type of access. Options are: Read Only and Read/

Write.

Encryption Protocol Select the encryption. Options are: None, DES, 3DES, AES.

Engine ID Enter an engine ID when you add a user that will be used for

SNMP v3 communications. The engine ID is made up of

hexadecimal digits with a colon separating each digit.

Leave the engine ID blank when you add a user that will have

access to the MIB, or in the case of SNMP v3 MIB queries.

Authentication Pass Phrase Enter the Authentication pass phrase for the service access

point. Press the Tab key when you have entered the phrase.

Privilege Pass Phrase Enter the Privilege pass phrase for the service access point.

Press the Tab key when you have entered the phrase.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 223 224

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 59