Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 80)

80 BCM450 MBM and legacy Norstar configuration

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

Variable definitions

Configuring expansion unit MBMs

Configure expansion unit media bay modules (MBM) through a two-stage

process. First, you identify the type of installed MBMs to the BCM system, and

then you configure the required variables. The BCM system suggests default

values for your MBM. You can modify this default configuration depending on

your system preference.

To configure MBMs in the expansion unit through Telset Administration, select

**Config > Hardware > Main Unit > Expansion.

Prerequisites

• If you do not configure the MBM, it cannot function in your system.

• You can force a specific dip switch setting for your MBMs. Nortel

recommends that you leave the dip switches in the default position. The

DIP switches in an expansion unit must be set to select a valid module

number.

• A FEM does not function in an expansion unit. A FEM must be installed in

the main unit.

Procedure steps

Step Action

1 Select Configuration > Resources > Telephony Resources.

2 In the Modules section, double-click Configured Device in the row where

Expansion 1 is located.

Variable Value

Module type This read-only value is the type of module allocated to this

resource. In this case the value is the type of MBM.

Start DN The lowest DN in the range of DNs assigned to your resource.

The DNs in the range can be consecutive or non-consecutive.

Public received digits/OLI The public received digits/OLI (outgoing line identification) are

the digits that display on the telephone called from this DN over

the public network. This number is usually the same as the DN.

Private received digits/OLI The private received digits/OLI (outgoing line identification) are

the digits that display on the telephone called from this DN over

the private network. This number is usually the same as the DN.

Assign target lines Select this checkbox to assign target lines to your DNs.

Start Line The first line number in the sequence of consecutive lines

assigned to your MBM.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 223 224

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 80