Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario descargar pdf (Pagina 18)

18 Fundamentals

Nortel Business Communications Manager 5.0

Configuration — System

NN40170-501 02.04 Standard

September 2009

Once a target line is configured with public or private numbers, deconfiguring

DNs that have appearances of those target lines does not remove the public

or private numbers from those target lines.

The DNs assigned to IP sets or applications do not need to be consecutive. If

the relevant pool DNs are renumbered or changed, so the consecutive DNs

do not exist, then the IP sets or applications have non-consecutive DNs. For

this reason the low and high values for IP sets and applications represent the

lowest and highest DN value currently in the respective assigned range. The

total number of DNs assigned is not all the DN values in between the low and

high values.

Configuring IP or Application DNs is a cumulative action. Every new

successful configuration request adds the relevant count of IP or Application

DNs to the existing range. Existing DNs are not affected or changed in any

way. The default number of DNs to add is normally zero. This is a protection

mechanism. You must change the number of DNs in the Number of DNs to

add field to the desired number of additional DNs.

When you configure DNs there is an exception to the number of DNs you can

add. The BCM 5.0 system requires a minimum of three configured application

DNs for applications to function correctly. When you configure application

DNs, if there are fewer than three currently configured application DNs, then

the minimum number possible to configure is set so that the final configured

application DN count is at least three. For example, if through Set-based

administration you complete a DN deconfiguration, and only two configured

application DN remains, then the next time you configure application DNs the

system would permit a minimum of two additional DNs to be configured for a

final total of three.

Finally, you can partially configure IP sets and applications (but not MBMs)

with fewer DNs than the licensed device count. The MBM needs to either read

MBM DNs or Digital/Analog station DNs. If there are not sufficient DNs defined

in the relevant pools then the number of available DNs are allocated to the

services list.

Main unit and expansion unit MBM configuration on BCM450

Attention: Main unit and expansion unit MBM configuration is applicable

only for BCM450

During media bay module (MBM) configuration, the BCM450 system provides

suggested default values for the MBM. These suggestions include DNs or line

numbers. If you change configuring data from the defaults provided and the

configuration fails, then the configuration reverts back to the suggested

values.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 223 224

Comentarios a estos manuales

Sin comentarios

Avaya Business Communications Manager 5.0 - Configuration - System Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Avaya Business Communications Manager 5.0 - Configuration - System