
BCM 5.0 internal resources configuration 73
Nortel Business Communications Manager 5.0
Configuration — System
NN40170-501 02.04 Standard
September 2009
Copyright © 2009, Nortel Networks
5 Click OK.
--End--
Variable definitions
Configuring IP sets and applications
The BCM system automatically configures your IP sets and applications
resource DNs. You can modify this default configuration to re-organize the
DNs on your system.
Author’s note: This procedure has not been tested as the functionality is not
yet available in the current software. It will be verified when the functionality
becomes available.
To configure IP sets and applications resources through Telset Administration,
select **Config > Hardware > Main unit > IP Sets.
Procedure steps
Step Action
1 Select Configuration > Resources > Telephony Resources.
2 In the Modules section, select the internal IP sets or Applications that you
want to configure.
Variable Value
Module type This read-only value is the type of module allocated to this
resource. In this case the value is IP Trunks.
Note A read-only value that provides information relevant to IP trunk
configuration.
Start Line The first line number in the sequence of consecutive lines
assigned to your IP Trunks.
The list of line numbers for IP trunks must be consecutive. If the
available line numbers are segmented and the necessary
number of consecutive line numbers does not exist, you receive
an error message and the system does not assign the line
numbers. If this occurs, you must remove other lines in the
system and restart line numbering for devices so the lines
numbers are not segmented and enough consecutive groups are
obtained for all devices.
Total Number of Lines The total number of lines that you want to assign to your IP Trunk
resource.
Comentarios a estos manuales