Avaya Configuring Dial Services Manual de usuario Pagina 99

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 326
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 98
114062 Rev. A
7-1
Chapter 7
Creating Line Pools
This chapter provides instructions on how to create demand, backup, and
bandwidth-on-demand line pools. The configuration procedures for creating line
pools are similar for all three dial services. To avoid repetition, this chapter shows
only the dial-on-demand configuration windows as examples. For dial backup or
bandwidth-on-demand pools, the window may have a different title, but the
procedure is the same.
This chapter assumes you have read
Configuring Routers
and that you have
1. Opened a configuration file
2. Specified router hardware if this is a local mode configuration file
3. Configured ports on the router that you want as a leased connections
(dial backup or bandwidth-on-demand only).
For dial backup and bandwidth-on-demand, select any COM or MCT1/E1
port on a link or net module and configure a leased interface before going to
the Dialup option on the Configuration Manager main menu (Figure
7-1).
Refer to
Configuring Routers
for instructions. Later, you designate these
interfaces as dial backup primary or bandwidth-on-demand circuits.
For dial-on-demand, you go directly to the Dialup option without selecting a
port.
To configure a line pool you
1. Define pool IDs.
2. Select one or more lines to include in each pool.
3. Configure the signaling method or service for each line (Raise DTR, V.25bis,
or ISDN).
Vista de pagina 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 325 326

Comentarios a estos manuales

Sin comentarios