
Configuring Dial Services
7-62 114062 Rev. A
Parameter: BRI Line Type
Default: PTP
Options: PTP
| MTP
Function: Indicates whether or not you have a point-to-point (PTP) or a multipoint
(MTP) configuration on the BRI line.
Instructions: Enter the value that indicates the type of line supplied by your network
provider.
If you have a point-to-point line connected to a 5ESS switch, you do not
have to configure SPIDs. (Refer to the SPID
parameter on page 7-52.)
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.8.9.1.33
Modifying the Logical Lines Configuration
Before you can delete or change the logical lines in a pool, first delete all circuits
associated with that pool. Refer to Chapter 8 for instructions.
You can modify the logical lines by following these steps:
1. Select Dialup > Demand, Backup, or Bandwidth On Demand Pools from
the Configuration Manager window.
Site Manager displays the Pools window (refer to Figure
7-2).
2. Highlight the pool ID that has the ISDN lines you want to modify and
click on Edit.
Site Manager displays the Lines Definition window (refer to Figure
7-4).
3. Click on the ISDN or MCT1/E1 connector and Site Manager displays the
ISDN Logical Lines window (r
efer to Figure 7-23 on page 7-43).
4. From the ISDN Logical Lines window you can
• Edit the pool channel count and priority.
• Click on Remove to delete ISDN service from a line.
5. Click on OK to exit the ISDN Logical Lines window. Select File > Exit to
exit the Lines Definition window.
6. Click on Done to return to the Configuration Manager.
Comentarios a estos manuales